Unregistered users may browse the website, but in order to participate in the forums and view select pages (such as "Club Contacts" and "Classified Ads") a user account is required. Click HERE to email the webmaster and request a free account. The National DeSoto Club uses real names rather than pseudonyms. Notify the webmaster of your user name preference (Johnathon Doe vs. John Doe, etc.), preferred email address, and password request.
Does the dual carb setup use paper element air filters? Steve
Paul, I'm not sure I understand your last post. The ignitor module for a 12 volt DeSoto Hemi v8 costs less than the ignitor module for a 6 volt DeSoto...
I installed the Ignitor module in the distributor today. The removal of the old points was the biggest chore, installation of the module was a snap. T...
I'm not sure if this would qualify as bait and switch. I searched their online catalog to find this part, and had to look it up by distributor number ...
Pertronix makes an ignitor module specifically for the 6v Positive ground Autolite IAZ distributor used by Chrysler on their early hemis. The part num...
No noise at all. The rubber boots were torn. Grease was escaping, and dirt was getting in. I just wanted to prevent future problems.
Steve, I welded a 5/16 diameter steel pipe down one of the header tubes and connected it to the choke heat tube hoping to emulate the stock choke's he...
Hi Tim, Thanks for the link. I got the brake job done tonight, and the car stops pretty well. I'm thankful that the master cylinder seems to work alri...